Applications
Used for maintaining temperature during transport of adhesives, oils, chocolate, gas, emulsions as well as alimentary,
cosmetic and pharmaceutical products.
Design
Consists of smooth PTFE tube sheathed with stainless steel, insulated by silicon foam (200°C) union with stainless steel
free nut ( BSP with cone 60°), temperature control by PT100 or thermocouple type J or K centered on the heating hose.
Elmatic Heated Hoses will heat electrically any type of flexible hose, either single hoses or
multiple hoses bunched together. We can also heat hoses supplied by customers, or advise on suitable alternatives.
The labelled diagram above is typical of the bulk of Heated Hoses that we undertake. We do however pride ourselves
on our individual service and our objective approach to each customer's particular needs.
We try therefore not to describe any particular construction as a standard heated hose, but offer a range of
variations, to suit each application.
The diagram also refers to a particular state of fabrication achieved at the present time. As a progressive and
innovative company we are always looking at new improvements in both materials and techniques and so we would reserve the right to
amend or modify any of the above in the light of continuing development.
All heated hoses must be connected to a suitable temperature controller otherwise damage will occur. Temperature
controllers for all
types or applications can be specified and supplied, either with the heated hoses, or separately.
LENGTH
To customers specification. (if longer than 17m this can be connected internally) |
|
|
| |
|
|
END FITTINGS
Swaged fittings, to most pipe thread systems, are in a range of materials. |
|
|
| |
|
|
BORE SIZE
Sizes to suit customer's specifications can be supplied.
Standard 1/8”, 3/8”, 1/2”, 3/4”, 1”, 1.1/8” |
|
|
| |
|
|
TEMPERATURE
To customers specification.(max. around 330 ° C at 100 bar) |
|
|
| |
|
|
PRESSURE
To customers specification.(Max. around 350 bar at 135 ºC) |
|
|
| |
|
|
TEMPERATURE SENSOR
PT 100 and thermocouple types of sensor can be supplied.
Other types may be available, by prior consultation. |
|
|
| |
|
|
HEATER
The heating element is insulated with a layer of silicone rubber for moisture protection. |
|
Standard |
| |
|
|
THERMAL INSULATION
A thick layer of closed cell silicone foam rubber. |
|
Standard |
| |
|
|
OUTER BRAID
Black polyamide sleeve braiding. |
|
Standard |
| |
|
|
END CAPS
Moulded silicone rubber caps are used exclusively. |
|
Standard |
| |
|
|
VOLTAGE
To customers requirements. |
|
|
| |
|
|
ELECTRICAL
The temperature sensing and the heating wires are standard. Additional wires, and/or tubes, can be incorporated in the build up, as necessary, to control customers operation or to feed additional equipment. |
|
Standard
Please advise if special
|
| |
|
|
|
